Laser Talk

3D Worktable Quick Introduction

This lasering worktable moves into all directions. The top plate can be adjusted in X and Y dimensions, as well as Z (height).

Especially helpful when you have to setup your engravable object in an awkward position to be in level, and would not want to move it around again.

Knives, guns – anything that isn’t leveled without support, you can set it up on this 3D worktable and use the knobs to fine tune instead of your hands.

3D table Dimensions:

Width 210 mm (+33 mm knob)
Length 150 mm(+33 mm knob)
Heigth 150 mm

X=80 mm
Y=50 mm
Z= 130mm

This product will be added to product options on August 5.